News Ticker

When Push Comes to Shove: Installing Push-Pull Cables

By Rizwan Ahmad - 28 August 2012 No Comments
Push Pull Cables
If you own or operate a boat, lawn mower, or anything else that has wheels you may have to replace the push-pull cables at some point. A lawnmower’s throttle uses this type of cable to adjust the flow of gas to the carburetor. Vehicles use this type of cable to operate the brakes and clutch. Boats use this type of cable to connect the steering wheel to the motor. Since push-pull cables have so many different types of fittings on their ends, it is very important that you measure them correctly to ensure the right length.

Measuring Push Pull Cables

Here are some quick tips on how to correctly measure a push-pull cable. First make sure you measure the cable without any of its end fittings from tip to tip. Then measure the cable with its terminal fittings from tip to tip. Terminal fittings can be either stops on the ends, cylinder-like studs, or round balls. Next lay out the cable on a flat, sturdy surface. Use a measuring tape but make sure you put the tip of the tape inside a either a loop or hook fitting on the left side of the cable. Stretch the measuring tape all the way down to the right side of the cable inside the same loop or hook.

Installing Push-Pull Cables
Next you have to measure a fork fitting on the end of the cable making sure you run it along the straight part of the fork. After you have done this, divide the measurement by 2, marking it with either a grease pencil or chalk. Do the same thing for the other side of the fork end. When this is complete put the end of the measuring tape on the center mark on one of the forks and measure all the way to the center mark on the other fork. Your next step is to put the end of the measuring tape on the center of the hole in a pin center fitting. Then measure all the way to the center of the hole on the other end of a pin center fitting. This type of fitting is made of a solid metal. It will have a hole in the middle of it near the end so that it can slide over a pin for the installation.

There you have it. If you are ever in need of replacing a push-pull cable you’ll know how to measure it properly before you install it. If you need more detailed steps to do this there are many references available online for you to utilize. But, it does feel good to be a do-it-yourselfer, doesn’t it?

Stephen Craig is a part of an elite team of writers who have contributed to hundreds of blogs and news sites. Follow him @SCraigSEO.

Rizwan Ahmad
About the Author:

This article is contributed by Stephen Craig and posted by Rizwan Ahmad Author and founder of cyberockk.com, He is a tech blogger from India and he loves to share his thoughts by writing articles on this site to the different topics related to technology world,

Tags:

No Comment to " When Push Comes to Shove: Installing Push-Pull Cables "